THIS
GUIDE APPLIES ONLY TO FMS-07 & FMS-12
SOLAR POWERED FIREFLY MAGIC™ LIGHT SETS.
CLICK
HERE for PDF Dowload
Please
Read all Installation Instructions BEFORE BEGINNING
Solar Powered FIREFLY
MAGIC™ Lights
Model FMS-07 & Model
FMS-12
1. Remove the clear, thin film, protective plastic
cover sheet from the top of the high efficiency
solar panel.
2. Twist the top cover counter-clockwise and
carefully separate it from the translucent plastic
diffuser globe.
3. While holding the AA
battery in place, pull out the plastic insulator
strip located at the + end the battery.
4. Next press the reset button
for 1-2 seconds and release it. This activates
the Firefly Magic™ fireflies and they should
all come on for 1-3 seconds then flicker off.
If any fireflies remain on longer than 4 seconds,
press the reset button again and release after
1-2 seconds. The firefly lights are now operating
correctly and will come on and go off very randomly.
NOTE:
The lantern diffuser globe is NOT designed to
light up. 
SEE OTHER SIDE FOR MORE
Next, let the firefly wires
slide down through the mounting post as you reinstall
the top cover
onto the diffuser globe. Twist the top cover
clockwise to lock onto the diffuser globe.
5. Carefully slide the mounting
stake into the mounting post. NOTE:
there is a notch near the top of the mounting
stake through which the firefly
wires must pass.
Selecting the Location for Your Firefly
Magic™ Fireflies
Most real fireflies tend to remain near the
ground, and by installing your fireflies the
same way, it will be an easy task.
6. Select a
location in your garden where you can run the
firefly wires to nearby foliage.
Ideally, the solar cell on the lantern fixture
should receive direct sunlight for several
hours each day to fully charged the two (2) AA
Ni-Cd
batteries.
7. After selecting the location,
hold the mounting post firmly in your hand and
press the mounting
stake into the ground. DO NOT PRESS
ON THE TOP COVER containing the solar panel
during
this
installation step, as permanent damage may
result. NOTE:
If the ground is hard, first dig a small
hole with a trowel and refill
the hole with
soft dirt to allow easy insertion of the
mounting stake.
8. Run each firefly wire along
the ground, up branches and out the stems of
plants to
reduce
their visibility. Be sure each firefly light
sticks out slightly so leaves do not cover
it. NOTE: If the firefly light
is placed near the end of a flexible stem or
branch,
any slight
breeze will cause the firefly light to move,
creating the added effect of fireflies dancing
in the night.
9. Aim each firefly light
approximately 90º from
where people will be viewing. This ensures the
firefly does not appear to be too bright by looking
directly into the end of the light. However,
if your firefly lights are farther away, or you
just prefer them to be brighter, then aim the
tip of the firefly light toward the viewers.
See diagram below:
10. Your Solar powered Firefly
Magic™ lights
use very little battery power so they are designed
to run continuously.
11. For best performance,
replace the batteries with rechargeable AA Ni-Cd
batteries
every
year. CAUTION: Ni-Cd BATTERIES CONTAIN
NICKEL-CADMIUM AND MUST BE RECYCLED OR DISPOSED
OF PROPERLY.
Other Firefly Magic™ Light Sets
Firefly Magic™ Lights are available in
three (3) Models: FMS - Solar powered, FMB -
Battery powered for temporary and semi-permanent
installations, and FMT - 12 Volt Landscape Lighting
transformer powered. Each of these models can
be ordered with either seven (7) electronic fireflies
or twelve (12) electronic fireflies. For more
information, visit our Website at www.FireflyMagic.com.
Patented
© 2004 Firefly Magic™ -
Apple Valley, CA 92307
install@fireflymagic.com
- 1-877-8-FIREFLY
For pricing and purchase information, Click
Here.
|
